Several members discussed their respiratory problems when working in the shop with certain types of wood. Wood dust affects everyone in different ways and one of the best ways I protect my lungs is by using Peke Safety’s Power Active …
For my last project, I needed to route out a large section at a even depth, so it finally made me make a sled to accomplish this task. The base is made from 3/4″ luan plywood. I first traced the …
Old rulers with etched markings could be revived in a 3 simple steps: Clean dirt and rust off with Scotchbright pad and WD40 or CLR calcium, lime, and rust remover. Paint over the etched markings (enamel paint). Make sure to …
I am getting into turning lately and built up a good selection of turning tools in my shop. To organize and make the tools easily reachable while turning, I created this 44-3/4″-wide tool rack on the wall right behind my …
To mount/release a NOVA scroll chuck from lathe spindle, you need a 1-1/2″ crescent wrench. These wrenches are expensive if you purchase one from woodworking/woodturning stores. I found a cheaper alternative… in an automotive section of a discount store. One …
Turned handles for campfire roasting forks. From left to right: Cypress, Maple, Maple & Walnut, and Cypress. Dust collection hood for router table. To be tested and refined.
